Thomas & Betts 20D, 15D Advanced Remote Control Panels Link Instrument, Link 2000R

OPTIONAL REMOTE CONTROL PANELS

Remote Control Panel

An optional remote control panel is

available. The LED bargraphs on the remote control panel shows battery voltage and DC current in both inverter and charger modes.

Easy to see red, yellow and green LEDs show the battery state-of-charge. Power Sharing, charger ON/OFF, inverter ON/OFF controls are provided. Set up features include selection of Idle Threshold, Battery Type and Battery Capacity.

Remote Control Panel

Advanced Remote Control Panels Link Instrument

Advanced remote control panels are also available: the Link 1000, 2000 and 2000R.

LINK 1000

Link 1000 controls the Freedom Inverter/ Charger and provides complete battery state-of-charge information including DC voltage, current, Amp-hours consumed, Time Remaining and historical data for a single battery bank.

LINK 1000

10

LINK 2000

The Link 2000 has the same features as the Link 1000, providing inverter/charger control and complete battery state-of-charge information. It monitors two battery banks.

LINK 2000

LINK 2000R

The Link 2000R adds the ability to regulate an engine-driven alternator. The precision regulator in the LINK 2000R allows the alternator to be controlled as a 3-stage battery charging system.

If Link Instrument is used to control the inverter/charger, refer to the Link Owner’s Manual for setup and control information.

Refer to the Remote Control Panel

or LINK Owner’s Manual for

installation and operation instructions

The jumper is not installed in the AUX Switch Port on the front panel of the inverter when the Remote Control Panel or Link Instrument is used. See page 23 for more details.

Part No. 90-0123-00 Libertycombi.p65 10/26/98