INSTALLATION PRECAUTIONS
CAUTION This equipment is not ignition protected and employs components that can produce arcs or sparks. To reduce the risk of fire or explosions, do not install in
unvented compartments containing
batteries or flammable gasses or areas in which
WARNING
For continued protection against risk of electric shock, use only the
CAUTION To reduce the risk of electric shock and prevent premature failure due to corrosion, do not mount where exposed to rain, dripping or spray.
CAUTION To reduce the risk of fire, do not obstruct ventilation openings. Do not mount in a zero clearance compartment, overheating may result.
CAUTION Risk of electrical shock. Both AC & DC voltage sources are terminated inside this equipment. Before servicing
disconnect all inputs and outputs.
Confirm that your shipping carton contains:
•Inverter/Charger
•TSC temperature sensor with 15’ cable
•Owners Manual
•Warranty Card
•Jumper for AUX Switch (only used without Remote Control Panel or Link Instrument)
•Wire Nuts
Typical Tools Needed
Flathead and Phillips Screwdrivers Allen (Hex) Screwdriver (1/8”)
Wrench for connecting battery cables (9/16”) Wire Cutters
Wire Strippers
Misc. assortment of wire ties and connectors
Accessories Needed for Installation Fuse - UL Listed DC Rated slow blow fuse as required by NEC
Electrical wire (10 gauge) for AC input wiring. Consult NEC for proper size for output wiring.
Battery Cables 1- Positive,
DC fuse cable Mounting Screws (4)
Freedom 15D
The Freedom 15D and 20D have
dual AC Outputs.
21
Part No.