Pelco C1619M-I manual Equipment Placement and Rack Mounting, Desktop Mounting

Equipment Placement and Rack Mounting

The Endura workstation can be placed on a flat surface, such as a desktop, or mounted in an equipment rack.

DESKTOP MOUNTING

WARNING: Do not place the Endura workstation unit on its side; in this position, the unit is likely to fall over and may cause equipment damage or personal injury.

To mount the Endura workstation on a desktop:

1.To prevent surface damage, be sure that the rubber feet are securely installed on the four corners of the bottom of the unit.

2.Remove the two chassis brackets (if attached) from the sides of the unit, using a Phillips screwdriver to remove the eight 10-32 x 0.25-inch Phillips pan head screws (four per bracket). Save the brackets and screws for possible future use.

3.Position the unit to allow for cable and power cord clearance at the rear of the unit. Be sure that the air flow around the unit is not obstructed.

(4)SCREWS

PER BRACKET, 10.32 X 0.25-INCH PHILLIPS PAN HEAD

CHASSIS

BRACKET

RUBBER FEET

(4) SCREWS,

8-32 X 0.25-INCH PHILLIPS PAN HEAD

Figure 5. Chassis Brackets and Rubber Feet

10 C1619M-I (11/07)