Pelco C1619M-I manual Product Serial Number Label Placement, Shown Actual Size

		REAR MOUNT RAIL
		2 EA.
			FRONT MOUNT RAIL
RACK MOUNT KIT			2 EA.	CHASSIS MOUNTING
				BRACKETS
SHOWN ACTUAL SIZE
PHILLIPS PAN	PHILLIPS TRUSS	PHILLIPS FLAT	PHILLIPS PAN	CAGE NUT,
HEAD SCREW,	HEAD SCREW,	HEAD SCREW,	HEAD SCREW,	10-32
10-32 X 0.25-INCH	8-32 X 0.375-INCH	10-32 X 0.5-INCH	10-32 X 0.75-INCH	10 EA.
8 EA.	6 EA.	4 EA.	4 EA.

Figure 3. Rack Mount Kit

PRODUCT SERIAL NUMBER LABEL PLACEMENT

Product serial number labels help Pelco’s Product Support identify your system and its factory configuration in the event that your Endura workstation or its components require service.

Three labels citing your product’s serial number are attached to the Endura workstation. One label is attached to the bottom of the Endura workstation. A second label is attached to the front panel of the unit, behind the bezel.

Because rack mounting and other installation options may obscure the factory-applied labels, a third label is provided for you to attach to your product documentation or another product location that will not be obscured by installation. To use this label:

1.Locate the small label attached to the outside of the front bezel with a yellow sticker that reads “Extra serial number label: remove prior to installation.”

2.Remove the yellow sticker.

3.Peel away the backing of the small white label and attach it to this Installation manual, other product documentation, or an unobscured product location.

03267-39-0020

Figure 4. Extra Product Serial Number Label

C1619M-I (11/07) 9