Pelco C1619M-I manual Rack Front

Page 13

RACK FRONT	RACK REAR
(4) SCREWS,	(4) SCREWS,
10-32 X 0.5-INCH	10-32 X 0.75-INCH
PHILLIPS FLAT HEAD	PHILLIPS PAN HEAD

FRONT-MOUNT RAIL

REAR-MOUNT RAIL

Figure 8. Attaching Support Rails

7.Repeat step 6 for the second support rail assembly.

8.Tighten the 8-32 x 0.375-inch Phillips truss head screws that were attached to the front- and rear-mount rails in steps 3 and 4.

C1619M-I (11/07)

13

Image 13

Contents Endura Workstation Page Rack Mount Kit List of IllustrationsContents Radio and Television Interference Regulatory NoticesDescription Before You Begin Parts ListPackage Contents Shown Actual Size Product Serial Number Label PlacementDesktop Mounting Equipment Placement and Rack MountingAssembling a Support Rail Repeat for the other rail set Rack MountingCage NUT Rack Front Tightening the Thumbscrews Connections Front Panel of Endura Workstation Bezel Open CONFIGURATION/RESET Button Front Panel IndicatorsOperation Updating the WS5000 Advanced System Software Installing the ApplicationProblem Possible Causes Suggested Remedy TroubleshootingSystem SpecificationsFront Panel C1619M-I 11/07 Product Warranty and Return Information ISO9001