Porter-Cable RS830 Removing Blade and Blade Guard from SAW, Disconnect Machine from Power Source

Page 10

REMOVING BLADE AND BLADE GUARD FROM SAW

1.DISCONNECT MACHINE FROM POWER SOURCE.

2.Loosen blade guard clamp knob (A) Fig. 11, and rotate blade guard (B) to the position shown.

3.With wrenches (C) Fig. 12, loosen arbor nut (D) as much as possible. NOTE: Arbor nut has left hand threads.

4.Lift cam (E) Fig. 13, which holds the blade guard (B) Fig. 12, in position and move the blade guard (B), outer blade flange (F), and blade (G) outward.

5.Lift blade guard (B) Fig. 14, and remove arbor nut (D), outer blade flange (F), and blade (G). Then remove blade guard (B).

A

B

Fig. 11

B

F

G

C

D

Fig. 12

E

Fig. 13

B

G

D

F

Fig. 14

10

Image 10
Contents Professional Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Avoid Kickback byGrounding Instructions Power ConnectionsMotor Specifications Qualified Electrician Check the ReceptacleChanging Voltage Extension CordsUnpacking and Cleaning Operating InstructionsRadial ARM SAW Parts Table Board Parts 811 912Legs to SAW Base AssemblyWrench Hook to SAW Base Disconnect Machine from Power Source Removing Blade and Blade Guard from SAWTable Supports Page HS a Disconnect Machine from Power Source Adjusting Checking SAW Blade Travel Square to FenceTable Board Clamps and Table Boards Page Checking and Adjusting SAW Blade Square To Table Removing Heeling in SAW Blade CUTAdjusting IN/OUT RIP Scale FJ aAssembling Blade and Blade Guard to Machine Tongue on Guard Seats Into Groove of CUTTING-HEADCutting Into Table Boards Fastening SAW to the FloorAdjusting Ball Bearings Against Track Locking Switch OFF PositionStarting and Stoping Radial ARM SAW Adjusting Tension on Elevating Column Changing Position of Track ARM Clamping HandleChanging Position of Yoke Clamp Handle Changing Position of Bevel Clamp HandleTable SURFACE, Raise Track ARM Positive Stop Yoke Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Bevel Index Explanation of Operating Controls CB KAuxiliary Table Board Facing OperationsOUT-RIPPING Compound Miter CuttingRipping IN-RIPPINGMaintenance Overload ProtectionPush Stick Constructing a Push StickPage Accessories PARTS, Service or Warranty Assistance