Porter-Cable RS830 instruction manual Assembly, Legs to SAW Base, Wrench Hook to SAW Base

Page 9

ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

LEGS TO SAW BASE

1.Loosen lock knob (A) Fig. 8, and move cutting-head

(B) to the rear position as shown. Then tighten knob (A).

2.IMPORTANT: Make certain the cutting-head is clamped securely at the back of the track arm.

3.Place Radial Arm Saw on its back and assemble legs

(C) Fig. 9 (three of which are shown assembled) to each corner of saw base (D) using sixteen 5/16-18 x 5/8" carriage head screws, 5/16" flat washers, 5/16" external tooth lockwashers, and 5/16-18 hex nuts. Place flat washer on bolt. Insert bolt through holes then assemble lockwasher and nut. Hand tighten, hardware at this time but do not completely tighten.

4.Stand the saw in the upright position and securely tighten all stand hardware.

A

B

Fig. 8

C

DC

Fig. 9

WRENCH HOOK TO

SAW BASE

Assemble wrench hook (K) Fig. 10, to the front right (as shown), or back left, side of saw base (D), using two #10 x 1/2" sheet metal screws.

D

K

Fig. 10

9

Image 9

Contents Professional Radial Arm Saw General Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM SawsMotor Specifications Power ConnectionsGrounding Instructions Qualified Electrician Check the ReceptacleExtension Cords Changing VoltageOperating Instructions Unpacking and CleaningRadial ARM SAW Parts 811 912 Table Board PartsAssembly Legs to SAW BaseWrench Hook to SAW Base Removing Blade and Blade Guard from SAW Disconnect Machine from Power SourceTable Supports Page HS a Adjusting Checking SAW Blade Travel Square to Fence Disconnect Machine from Power SourceTable Board Clamps and Table Boards Page Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To TableFJ a Adjusting IN/OUT RIP ScaleTongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to MachineFastening SAW to the Floor Cutting Into Table BoardsLocking Switch OFF Position Adjusting Ball Bearings Against TrackStarting and Stoping Radial ARM SAW Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating ColumnChanging Position of Bevel Clamp Handle Changing Position of Yoke Clamp HandleTable SURFACE, Raise Track ARM Adjusting Splitter and ANTI-KICKBACK Fingers Positive Stop Yoke IndexPositive Stop Bevel Index CB K Explanation of Operating ControlsOperations Auxiliary Table Board FacingRipping Compound Miter CuttingOUT-RIPPING IN-RIPPINGOverload Protection MaintenanceConstructing a Push Stick Push StickPage Accessories PARTS, Service or Warranty Assistance