Porter-Cable RS830 instruction manual

6.When both right and left edges of the table board are the same distance from the table supports, tighten four screws located in holes (N) Fig. 21, of front table board (A).

7.Insert four 1/4-20x1-1/4" round head screws (P) Fig. 22, into holes (R) Figs. 21 and 22, of the table board as shown, and tighten each of the screws until each corner of the table board raises approximately 1/8".

8.Loosen bevel clamp lever (S) Fig. 23, pull out bevel index knob (T), and rotate motor (V) to the vertical position as shown, until bevel index engages. Then tighten bevel clamp lever (S). NOTE: If the motor shaft contacts the table board before the motor is fully rotated, raise the track arm (X) Fig. 24, by turning elevating handle (C).

9.Loosen cutting-head clamp knob (W) Fig. 23, and move cutting-head to the front of track arm (X). Then tighten cutting-head clamp knob (W).

10.Loosen track arm clamp handle (Y) Fig. 24. NOTE: Track clamp handle (Y) Fig. 24, has left handed threads. Press down on indexing release handle (Z) Fig. 24, and pivot track arm (X) Fig. 24, to the left until motor shaft (B) Fig. 25, is near front left adjustment screw (P) Fig. 25, of table board (A) Fig. 25, as shown. Then tighten track arm clamp handle (Y) Fig. 24.

R

R

N

R

R

NA

Fig. 21

P

R

P

R

Fig. 22

X

W

V

T

S

Fig. 23

C

Z

X

Y

W

Fig. 24

12