Porter-Cable RS830 Table Board Clamps and Table Boards, Disconnect Machine from Power Source

TABLE BOARD CLAMPS AND TABLE BOARDS

1.Locate table board clamps (A) Fig. 29, and insert one clamp into each of the slotted holes (B) located at the rear of each table support bracket (C) as shown in Fig. 30.

2.Turn adjusting screw (D) Fig. 30 counter clockwise, so that the knobs (A) are in the rear position as shown.

A

B

C

Fig. 29

A D

A D

3.Place 1-1/4" wide board (E) Fig. 31, against front table board (G), and 5-3/4" wide board (J) against 1-1/4" wide board (E), place the 1-3/4" wide board (H) in the upright position against the 5-3/4" wide board (J) as shown. Then tighten knobs (D), until the table boards are securely clamped in position.

ADJUSTING

AND CHECKING

SAW BLADE TRAVEL

SQUARE TO FENCE

1. DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 30

H

D

Fig. 31

B

G

J E

2.	Raise track arm (A) Fig. 32, by turning elevating
handle (B) until the blade (C) can be assembled on the
motor shaft. Then tighten arbor nut (D) using the
wrenches supplied.
3.	Place a framing square (E) Fig. 32, against fence (H)
as shown, and lower track arm (A) until the blade just
clears the table surface.

A

C

H

ED

Fig. 32

14