Porter-Cable RS830 instruction manual Cutting Into Table Boards, Fastening SAW to the Floor

Page 19

CUTTING INTO

TABLE BOARDS

1.Assemble table boards (A) Fig. 48, and fence (B) as shown and secure in place with table clamps, one of which is shown at (C).

2.Return cutting-head (D) Fig. 49, to rear of track arm (E), and tighten cutting-head clamp knob (G) Fig. 48. Make sure switch (H) Fig. 49, is in the “OFF” position and connect saw to power source.

3.While holding cutting-head handle (L) Fig. 49 firmly, turn switch (H) “ON” and lower track arm (E) by turning elevating handle (K) as shown. Lower saw blade until it cuts into the table surface approximately 1/16” deep. Then stop turning elevating handle (K).

4.While still holding cutting-head handle (L) Fig. 50 firmly, loosen cutting-head clamp knob (G) Fig. 48, and slowly pull cutting-head (D) Fig. 50, toward the front of the track arm (E) as shown, until travel stops. Then turn switch (H) “OFF”.

5.Once saw blade (M) Fig. 51, has come to a complete stop, return cutting-head (D) to rear of track arm (E) as shown. Fig. 51, illustrates saw kerf (N) cut into table boards.

IMPORTANT: THE TRACK ARM (E) FIG. 51, MUST BE RAISED BEFORE ATTEMPTING TO ROTATE IT. ALSO, THE PROCEDURE “CUTTING INTO TABLE BOARDS” MUST BE PERFORMED FOR EACH ANGLE CUT DESIRED.

FASTENING SAW TO THE FLOOR

If during operation there is any tendency for the saw to tip over, slide, or walk on the supporting surface, the saw should be secured to the floor surface through holes provided on the bottom of each leg.

G

B

C

A

Fig. 48

K

E

D

H

 

L

 

Fig. 49

D

E

H

 

L

Fig. 50

E

D

M

N

Fig. 51

19

Image 19
Contents Professional Radial Arm Saw General Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM SawsQualified Electrician Check the Receptacle Power ConnectionsMotor Specifications Grounding InstructionsExtension Cords Changing VoltageOperating Instructions Unpacking and CleaningRadial ARM SAW Parts 811 912 Table Board PartsLegs to SAW Base AssemblyWrench Hook to SAW Base Removing Blade and Blade Guard from SAW Disconnect Machine from Power SourceTable Supports Page HS a Disconnect Machine from Power Source Adjusting Checking SAW Blade Travel Square to FenceTable Board Clamps and Table Boards Page Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To TableFJ a Adjusting IN/OUT RIP ScaleTongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to MachineFastening SAW to the Floor Cutting Into Table BoardsAdjusting Ball Bearings Against Track Locking Switch OFF PositionStarting and Stoping Radial ARM SAW Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating ColumnChanging Position of Yoke Clamp Handle Changing Position of Bevel Clamp HandleTable SURFACE, Raise Track ARM Positive Stop Yoke Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Bevel Index CB K Explanation of Operating ControlsOperations Auxiliary Table Board FacingIN-RIPPING Compound Miter CuttingRipping OUT-RIPPINGOverload Protection MaintenanceConstructing a Push Stick Push StickPage Accessories PARTS, Service or Warranty Assistance