Porter-Cable RS830 instruction manual Table Supports

TABLE SUPPORTS

1.Place front table board (A) Fig. 16, on a stable surface with counter-bored holes facing down, as shown.

2.Fasten left and right table supports (B) Fig. 16, to bottom of front table board (A) as shown, by inserting four 1/4-20x1" round head screws up through counterbored holes (D), in table board (A) and table supports (B). Secure in place using four 1/4-20 flanged hex nuts. Do not completely tighten nuts at this time.

3.Place front table board (A) Fig. 17, onto saw base (G), so that table supports (B) straddle the outside of saw base (G) and three holes (H) in each table support

(B) line up with three slots (J) in each side of saw base

(G) as shown.

B		B
	A
		D
		D
	Fig. 16

A

HB

J

G

4.Secure table supports, one of which is shown at

(B) Fig. 18, to each side of saw base using six 5/16- 18x5/8" carriage head screws (L) and six 5/16-18 flanged hex nuts. Do not completely tighten nuts at this time. IMPORTANT: Insert screws through table supports and saw base from the outside.

5.Using a combination square (M) Fig 20, check the left and right front edge of table board (A) to make certain both sides are the same distance from the edge of each table support (B) Fig. 20.

Fig. 17

B

L

Fig. 18

AM

B

Fig. 20

11