Oregon 613GC manual System CLEAN-UP

Page 15

613GC OPERATOR’S MANUAL

OPERATION

SYSTEM CLEAN-UP

•After cutting, run the cut-off saw for at least 15 seconds with the water on to flush slurry and debris from diamond chain, guide bar and drive sprocket.

•Wash concrete slurry from cut-off saw assembly.

•Avoid getting any water in the carburetor or exhaust system. If water enters exhaust port, point the guide bar tip down and pull the starter handle several times to expel water from muffler.

•Remove guide bar and diamond chain. Flush out the chain tensioner with high water pressure and lube with grease.

•After cleaning the cut-off saw, spray the entire saw body, diamond chain, guide bar, and drive sprocket with a lightweight oil. Using lightweight oil on the cut-off saw will minimize rust and help reduce slurry build up.

15

Image 15

Contents CUT-OFF SAW 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual Symbols & Labels Following Symbol Applies to ALL the Items Listed on this General Safety Precautions Following Symbol Applies to ALL Items Listed on thisEngine BREAK-IN Technical Specifications Guide BAR and Diamond Chain Installation SET-UP Fuel Handling Fuel MixingFueling Starting and Stopping a CHAIN-BASED CUT OFF SAW Cold Engine Starting ProcedurePlanning the CUT PRE-CUT ChecklistCutting Tips Cutting with the 613GC CUT-OFF SAWSystem CLEAN-UP After Each USE After 10 Hours of USEAfter 40 Hours of USE Starter Housing Assembly Starter Cord ReplacementAIR Filter Tensioning the Recoil Spring Drive Sprocket Chain TensionerDrive Sprocket Installation Drive Sprocket RemovalSpark Plug Carburetor Guide Bars Further questions? Call 1-800-321-1240 or 613GC OPERATOR’S Manual Approximate Cutting RatesINCH-FOOT Definition 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual