Oregon manual 613GC OPERATOR’S Manual, Approximate Cutting Rates, INCH-FOOT Definition

Page 24

		613GC OPERATOR’S MANUAL

		REFERENCE
APPROXIMATE CUTTING RATES

	Material	Cutting Rate
	Hard aggregate & Steel	15-25 sq-in/min (90-160 sq-cm/min)

	Medium aggregates	20-30 sq-in/min (160-190 sq-cm/min)

	Masonry, Soft aggregates	30-50 sq-in/min (190-320 sq-cm/min)

INCH-FOOT DEFINITION

An in-ft is a measure of how much material is to be cut.

An in-ft is defined as: depth in inches times length in feet.

Note: 129 in-ft = 1m2

Example: How many in-ft are in this doorway?

1.Determine the depth of the cut in inches. For this example, 8 inches.

2.Determine the length of the cut in feet. 3+7+3+7=20 feet

3.Multiply the two numbers 8 in x 20 ft = 160 in-ft

24

Image 24

Contents CUT-OFF SAW 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual Symbols & Labels Following Symbol Applies to ALL the Items Listed on this Following Symbol Applies to ALL Items Listed on this General Safety PrecautionsEngine BREAK-IN Technical Specifications Guide BAR and Diamond Chain Installation SET-UP Fuel Handling Fuel MixingFueling Cold Engine Starting Procedure Starting and Stopping a CHAIN-BASED CUT OFF SAWPRE-CUT Checklist Planning the CUTCutting with the 613GC CUT-OFF SAW Cutting TipsSystem CLEAN-UP After Each USE After 10 Hours of USEAfter 40 Hours of USE Starter Housing Assembly Starter Cord ReplacementAIR Filter Tensioning the Recoil Spring Chain Tensioner Drive SprocketDrive Sprocket Installation Drive Sprocket RemovalSpark Plug Carburetor Guide Bars Further questions? Call 1-800-321-1240 or 613GC OPERATOR’S Manual Approximate Cutting RatesINCH-FOOT Definition 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual