Oregon 613GC manual Drive Sprocket Removal, Drive Sprocket Installation, Spark Plug

Page 20

613GC OPERATOR’S MANUAL

MAINTENANCE

DRIVE SPROCKET REMOVAL

•Remove the side cover, guide bar, diamond chain, and clutch slurry shield.

•Remove the spark plug and insert the piston stop (supplied with each cut-off saw) into the spark plug hole. Pull the starter cord slowly until the piston stops. (Figure 1) Use a 19mm wrench to turn the clutch clockwise and remove.

•Slide the clutch cup/drive sprocket assembly off the shaft. Remove the needle bearing and inspect for heavy wear

or damage.

Figure 1

 

DRIVE SPROCKET INSTALLATION

•Slide the rim sprocket onto the splined adapter, either side out.

•Apply a liberal amount of grease to the needle bearing.

•Place the thin metal washer onto drive shaft. Slide the needle bearing and clutch cup w/rim sprocket onto shaft (Figure 2).

•Install the clutch by turning it counter clockwise on the

drive shaft and firmly tighten. Replace the clutch slurry shield. Installation of drive sprocket assembly is now complete.

SPARK PLUG

•A worn or fouled spark plug can cause a loss of power, difficulty starting or rough idle (Figure 3).

•If the spark plug is dirty clean it with a wire brush and check the electrode gap. Readjust if necessary. The correct gap is (020” (0.50mm)

•The spark plug should be replaced after 40 hours of operation or earlier if the electrode is badly corroded.

•Always use the recommended spark plug type, Using the wrong spark plug can severely damage the piston and cylinder. (Champion RCJ7Y).

Figure 2

Figure 3

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents CUT-OFF SAW 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual Symbols & Labels Following Symbol Applies to ALL the Items Listed on this Following Symbol Applies to ALL Items Listed on this General Safety PrecautionsEngine BREAK-IN Technical Specifications Guide BAR and Diamond Chain Installation SET-UP Fueling Fuel HandlingFuel Mixing Cold Engine Starting Procedure Starting and Stopping a CHAIN-BASED CUT OFF SAWPRE-CUT Checklist Planning the CUTCutting with the 613GC CUT-OFF SAW Cutting TipsSystem CLEAN-UP After 40 Hours of USE After Each USEAfter 10 Hours of USE AIR Filter Starter Housing AssemblyStarter Cord Replacement Tensioning the Recoil Spring Chain Tensioner Drive SprocketSpark Plug Drive Sprocket InstallationDrive Sprocket Removal Carburetor Guide Bars Further questions? Call 1-800-321-1240 or INCH-FOOT Definition 613GC OPERATOR’S ManualApproximate Cutting Rates 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual
Top Page Image Contents