Oregon 613GC Following Symbol Applies to ALL Items Listed on this, General Safety Precautions

613GC OPERATOR’S MANUAL

SAFETY

THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE

CAUTION

A potentially hazardous situation exists which, if not avoided, may result in minor or moderate injury or property damage.

•Always turn a chain-based cut off saw OFF when performing maintenance on the saw including diamond chain tensioning.

•Never use equipment that is not functioning properly. Have the cut-off saw repaired by qualified service personnel.

•Turn engine OFF before refueling. Keep away from open flame. Always provide adequate ventilation when handling fuel. Move chain-based cut off saw at least 10 feet (3 m) away from refueling area before starting.

•SealPro® diamond chains require a minimum water pressure of 20 psi (1.4 bar). Insufficient water supply may result in excessive wear to the diamond chain, which can lead to loss of strength and diamond chain breakage.

•Never start a chain-based cut off saw unless the guide bar, diamond chain and side cover are properly installed.

GENERAL SAFETY PRECAUTIONS

•Always wear protective clothes, including hard hat, eye protection, hearing protection, and gloves.

•Avoid loose fitting clothing.

•Perform safety checks before starting each day.

•Always operate tool with solid footing and with both hands on cut-off saw.

•Remove or control slurry to prevent slippery conditions while cutting.

•Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary people present.

•Set up a well-marked safety zone with a roped boundary and clear signs.

•Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is dangerous.

•To avoid electrocution, check for live electrical wiring near cutting area.

6