Oregon 613GC manual Symbols & Labels

Page 4

613GC OPERATOR’S MANUAL

SYMBOLS & LABELS

THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND THROUGHOUT THIS MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES.

WARNING

IMPORTANT

A potentially hazardous situation exists which, if not avoided, could result in death or serious injury.

A potentially hazardous situation exists which, if not avoided, may result in minor or moderate injury or property damage.

A potential situation exists which, if not avoided, may result in product or property damage.

THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE CUT-OFF SAW

Read the operator’s manual carefully and understand the contents before you use this equipment.

Always use:

•Protective helmet

•Ear protection

•Protective glasses or full face protection

Wear hand protection

4

Image 4

Contents CUT-OFF SAW 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual Symbols & Labels Following Symbol Applies to ALL the Items Listed on this Following Symbol Applies to ALL Items Listed on this General Safety PrecautionsEngine BREAK-IN Technical Specifications Guide BAR and Diamond Chain Installation SET-UP Fuel Mixing Fuel HandlingFueling Cold Engine Starting Procedure Starting and Stopping a CHAIN-BASED CUT OFF SAWPRE-CUT Checklist Planning the CUTCutting with the 613GC CUT-OFF SAW Cutting TipsSystem CLEAN-UP After 10 Hours of USE After Each USEAfter 40 Hours of USE Starter Cord Replacement Starter Housing AssemblyAIR Filter Tensioning the Recoil Spring Chain Tensioner Drive SprocketDrive Sprocket Removal Drive Sprocket InstallationSpark Plug Carburetor Guide Bars Further questions? Call 1-800-321-1240 or Approximate Cutting Rates 613GC OPERATOR’S ManualINCH-FOOT Definition 613GC OPERATOR’S Manual 613GC OPERATOR’S Manual