GENERATOR SHUT-DOWN PROCEDURES
WARNING
NEVER stop the engine suddenly except in an emergency.
NORMAL SHUTDOWN PROCEDURE
To shutdown the generator, use the following procedure:
1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 35 to the OFF position.
2.Place the engine speed switch (Figure 53) in the “LOW” (down) position.
EMERGENCY SHUTDOWN PROCEDURE
1.Place the ECU Control Switch switch (Figure 54) to the OFF/Reset position.
2.To
Figure 53. Engine Speed Switch (Low)
3.Let the engine cool by running it at low speed for
4.Place the MPEC Control Switch (Figure 54) to the OFF/RESET position.
Figure 54. MPEC Control Switch (Off/Reset)
5.Verify that all the status LEDs on the MPEC display are OFF (not lit).
6.Remove all loads from the generator.
7.Inspect entire generator for any damage or loosening of components that may have occurred during operation.
DCA125SSIU 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (12/22/08) — PAGE 37