Installation
3.Determine the height position inside the rack enclosure where you want to mount the UPS or battery cabinet.
CAUTION
! Reduce risk of tipping the rack enclosure by placing UPS or battery cabinet in the lowest possible rack position.
Install rear member of each |
| M5 screws | |
bracket assembly into rack | Front rack | ||
| |||
enclosure with two (2) M5 | mounting rails |
| |
screws provided in this kit. |
|
| |
(See figure at right.) Return |
|
| |
flanges on bracket assembly |
|
| |
fit to the inside of rack |
|
| |
mounting rails. Insert screws |
|
| |
loosely |
|
| |
and bottom holes of return |
| Rear rack | |
flange on rear member. |
| mounting | |
Extend bracket assembly by | M5 screws | rails | |
sliding front member for- |
|
|
ward until it touches the front rack mounting rail. Insert two (2) M5 screws loosely
4. Locate eight (8) M4 screws and eight (8) M4 nuts from hardware pack in this kit.
Each nut has a locking, nylon insert that begins gripping the screw when it is halfway tight. Make sure to tighten nut and screw completely to assure locking action. Fasten rear member and front member together using four
(4) screws and four (4) nuts
per bracket assembly as shown in the figures at right.
For maximum support, locate fasteners for each bracket assembly as far apart as possible, depending
on rack depth, while still joining both members (See
figures at right). Check alignment of bracket assemblies and TIGHTEN ALL SCREWS FROM STEPS 3 and 4.
10 | DISCONTINUED |
| PRODUCT |