Lux Products TX9600TS operating instructions Battery Replacement

Page 32

Reset, press and hold the Software Reset button for at least 5 seconds. The LCD display screen will become fully populated, then return to normal. The thermostat will still retain the current day and time even after a Software Reset has been performed.

COMPRESSOR PROTECTION BYPASS: This optional feature permits the installer or service technician to temporarily disable the built in compressor protection delays. This is most useful for diagnosing and testing the heating and cooling systems after installation is complete, and should not be used during normal operation. To activate this feature, start with the System Mode switch in either the Heat or Cool positions, then change to the OFF position. Press and hold the OK button for at least 5 second. The thermostat will give a single beep sound to confirm that this feature has been activated. All compressor protection delays (in all modes of operation) will be disabled for 5 minutes. After the 5-minute duration has expired, the thermostat will return to normal operation automatically.

BATTERY REPLACEMENT:

This thermostat is powered by two “AA” Alkaline batteries. The batteries should be replaced AT LEAST once per year to ensure reliable operation (or sooner, if the “LO-BATTERY” icon appears at the bottom of the display screen). The batteries are located on the back of the thermostat, at the top of the circuit board. The front portion of the thermostat can be removed from the back half by pulling straight outwards on the top and bottom of the thermostat housing, at the large indentations that are present in the center of the top and bottom edges.

When installing new batteries, we recommend using only brand new Energizer® or DURACELL® , “AA” size alkaline batteries. Please observe the polarity markings shown in the battery compartment to ensure proper installation. When finished, line up the front of the thermostat to the base, and firmly press together to securely latch the front and back halves together properly.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents 9 6 0 0 T S Not Compatible with System CompatibilityCompatible with Features Tools YOU MAY NeedMounting Location Remove OLD ThermostatInstall Thermostat Base Thermostat TOP ViewWiring Base Plate Notice Wiring InformationConnecting the Wires Wiring Diagram Notes Important, please read all notes before connecting wiresWiring Diagrams FAN Wire HOT Water Heating only With a 3-WIRE Zone Valve STAGE, Cooling only Conventional NON Heat Pump Stage Heating and 1-STAGE CoolingStage Heating and 1-STAGE Cooling Conventional NON Heat PumpWith TWO Separate 24V Transformers SINGLE-STAGE Heat Pump System With no AUX or Emergency Heat Heat / 1-COOL, Heat Pump System With AUX and Emergency HeatHardware Setup Options Described in the Advanced Features Section of this manualPage GAS / Elec Slide Switch FAN Operation Complete the InstallBattery Front Panel ItemsTouchscreen Menu Contents Operating InstructionsNite DAYEVE Page Temperature Programs Advanced Features Degrees F Page Page Page Page Page RST Battery Replacement Technical Assistance Limited Warranty Mercury Warning and Recycling Notice˚ F
Top Page Image Contents