Lux Products TX9600TS operating instructions Install Thermostat Base, Thermostat TOP View

INSTALL THERMOSTAT BASE:

Large Indentation:

Front Housing ReleaseMode

Switches

THERMOSTAT TOP VIEW

1.Strip wire insulation leaving only 3/8 in. (9.5mm) bare wire ends, and clean off any corrosion present.

2.Fill the wall opening with non-combustible insulation to prevent drafts from affecting the thermostat’s normal operation.

3.Route the wires through the opening in the new thermostat base plate, and hold the base against the wall. Try to line up the screw holes from the prior thermostat, and install the mounting screws.

4.If the previous holes cannot be used, hold the thermostat base against the wall so that it appears straight and level (position the base for best appearance) and mark for the new screw holes. Attach the base to the wall using the screws provided (use the supplied plastic anchors if needed when mounting to a soft material such as drywall).

5