2.Attach the bottom braces to the legs, as shown in Figure 7, with the remaining (16)
x 16
Figure 7. Bottom braces attached to the legs.
3.Slide the leg foot pads onto the bottom of the legs, as shown in Figure 8.
Foot
Pad
Figure 8. Leg foot pad installed.
4.Carefully turn the stand over, square up the legs and braces, then fully tighten all fasten- ers.
5.Attach the wheel brackets to the rear legs with (4) M8-1.25 x 16 hex bolts and M8-1.25 lock nuts (see Figure 9).
Note: The left and right wheel brackets are different configurations.
x 4
Cotter Pin
Figure 9. Wheels assemblies.
6.Slide the wheel axle through the brackets, put the wheels onto the ends of the axle, then secure them with the cotter pins by inserting them through the axle holes and bending back the ends.
7.Attach the lifting handle assemblies on the front legs with (4) M6-1 x 10 flat head screws and M6-1 lock nuts, as shown in Figure 10.
x 4