Grizzly G0622 Stand Assembly, Components and Hardware Needed Qty, To assemble the stand

Stand Assembly

Components and Hardware Needed:	Qty
Bandsaw	1
Hex Bolts M6-1 x 12	8
Flat Washer 6mm	12
Hex Nuts M6-1	12
Stand Legs	2
Corner Support Braces	4
Axle	1
Wheels	2
Cotter Pins	4
Transport Handle	1
Wheel Mounting Bracket	1
Hex Bolts M8-1.25 x 20	6
Hex Nuts M8-1.25	6
Flat Washers 8mm	6
Tool Tray	1
Phllips Head Screws M6-1 x 12	4
To assemble the stand:

1.Unfold the two stand leg assemblies. They are hinged on the edges for easy set up.

2.Using the M6-1 hex nuts, hex bolts and flat washers, install the corner support braces in the bottom corners of the leg assemblies (Figure 5).

3.On one of the leg assemblies, attach the wheel mounting bracket along with the cor- ner support braces to the outside bottom edge as shown in Figure 5.

Corner Support

Braces

Wheel Mounting

Bracket

Figure 5. Corner braces and wheel bracket.

4.Slide the axle through the holes in the mount- ing bracket on the bottom edge of the stand.

5.Slide the wheels onto the axle on the outside of the mounting brackets, and secure with the cotter pins as shown in Figure 6.

Cotter Pin

Figure 6. Wheel assembly.

6.On the other leg, Insert the handle into the pre-drilled holes and secure with the cotter pins (see Figure 7).

Cotter Pin

Figure 7. Cotter pins installed into the handle.

-14- G0622 4" X 6" Metal Cutting Bandsaw