Grizzly G0622 owner manual Adjusting table level Safety Bracket Pin

Page 20

5.Place a level on the table, as shown in Figure 18, and adjust the adjustment bolt shown in Figure 19 until the table is level.

6.Install the safety bracket and lock in place with the pin shown in Figure 20 to keep the saw from falling.

Note: To ensure the safety bracket fits securely in the notch on the body frame, the safety bracket may need to be slightly "modi- fied" with a hammer or other appropriate implement to fit securely.

Figure 18. Adjusting table level.

Safety Bracket

Pin

Figure 19. Adjustment bolt.

-18-

Figure 20. Safety bracket.

G0622 4" X 6" Metal Cutting Bandsaw

Image 20

Contents Model G0622 Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Other Identification Safety G0622 4 X 6 Metal Cutting BandsawG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws Circuit Requirements 110V OperationSET UP Set Up SafetyItems Needed for Set Up UnpackingHardware Bag not shown InventoryBox 1 Figure Qty Hardware Recognition Chart Clean Up Site ConsiderationsTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty Installing Pulleys To install the pulley coverTo install the V-belt around the pulleys Installing V-BeltTo install the pulleys Ting Installing Work Stop Vertical AssemblyTo assemble the bandsaw for vertical cut Adjusting table level Safety Bracket Pin Factory adjustments that should be verified Test Run RecommendedOperations Operation Safety ViseTo adjust the angle on the vise Blade Speed Belt PositionBlade Selection To change the blade speedsTo adjust the blade guides To adjust the feed rateBlade Guides Feed RateTips for vertical cutting Operation TipsTips for horizontal cutting Accessories H5408-Blade Tensioning GaugeH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Maintenance CleaningSchedule LubricationService TroubleshootingSymptom Possible Cause Corrective Action Blade Change To change the blade on the bandsawTo adjust the blade tracking on the bandsaw Blade TrackingTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw To adjust the blade guide bearings Blade Guide BearingsWiring Diagram Electrical ComponentsParts Breakdown Parts List DescriptionSliding Plate Draw Block Warranty and Returns Page Page