Grizzly G0622 owner manual Installing Pulleys, To install the pulley cover

Page 17

7.With the help of an assistant, lift the bandsaw onto a pair of closely spaced sawhorses or other suitable support (see Figure 8).

Figure 8. Leg assembly.

8.Attach the legs to the bandsaw with the M8- 1.25 x 20 hex bolts, flat washers, and hex nuts.

Note: At this time, tighten with a 14mm wrench or socket just enough to secure the parts. Final tightening will take place when the stand is fully assembled.

9.Remove the sawhorses and install the tool tray in the middle of the stand as shown in Figure 9 with M6-1 Phillips head screws, flat washers and hex nuts.

Figure 9. Tool tray.

10.Check to see if the bandsaw is relatively level then final tighten all the nuts.

G0622 4" X 6" Metal Cutting Bandsaw

Installing Pulleys

The V-belt drive system for the bandsaw requires the installation of two pulleys. The pulleys are covered for operator safety and to keep the V-belt and pulleys clean.

Components and Hardware Needed:	Qty
Pulley Cover	1
Pulleys & Keys	2
Phillips Head Screws M6-1 x 25 (installed)	2
Flat Washers 6mm (installed)	2
To install the pulley cover:

1.KEEP BANDSAW UNPLUGGED!

2. Place the pulley cover over the motor and gear shafts, and secure with the (already installed) M6-1 x 12 Phillips head screws and flat washers as shown in Figure 10.

Figure 10. Installing pulley cover.

-15-

Image 17

Contents Model G0622 Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Other Identification G0622 4 X 6 Metal Cutting Bandsaw SafetyG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws 110V Operation Circuit RequirementsSet Up Safety SET UPItems Needed for Set Up UnpackingHardware Bag not shown InventoryBox 1 Figure Qty Hardware Recognition Chart Site Considerations Clean UpTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty To install the pulley cover Installing PulleysTo install the V-belt around the pulleys Installing V-BeltTo install the pulleys Ting Installing Work Stop Vertical AssemblyTo assemble the bandsaw for vertical cut Adjusting table level Safety Bracket Pin Test Run Recommended Factory adjustments that should be verifiedOperations Operation Safety ViseTo adjust the angle on the vise Belt Position Blade SpeedTo change the blade speeds Blade SelectionTo adjust the feed rate To adjust the blade guidesBlade Guides Feed RateTips for vertical cutting Operation TipsTips for horizontal cutting H5408-Blade Tensioning Gauge AccessoriesH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Cleaning MaintenanceSchedule LubricationTroubleshooting ServiceSymptom Possible Cause Corrective Action To change the blade on the bandsaw Blade ChangeBlade Tracking To adjust the blade tracking on the bandsawTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw Blade Guide Bearings To adjust the blade guide bearingsElectrical Components Wiring DiagramParts Breakdown Description Parts ListSliding Plate Draw Block Warranty and Returns Page Page