Grizzly G0622 owner manual Test Run Recommended, Factory adjustments that should be verified

Page 21

Test Run

Recommended

 

 

Adjustments

 

 

 

 

 

 

 

 

 

 

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Starting the machine:

1.Read the entire instruction manual.

2.Make sure all tools and foreign objects have been removed from the machine.

3.Connect the bandsaw to power.

4.Put on safety glasses and secure loose clothing or long hair.

5.Raise the bandsaw by the handle.

6.Start the bandsaw while keeping your finger near the ON/OFF switch at all times dur- ing the test run (Figure 21). The bandsaw should run smoothly with little or no vibra- tion.

—If you suspect any problems, immediately stop the bandsaw and correct before con- tinuing.

—If you need any help with your bandsaw call our Tech Support at (570) 546-9663.

Figure 21. ON/OFF switch.

G0622 4" X 6" Metal Cutting Bandsaw

The adjustments listed below have been per- formed at the factory. However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the adjustments remain unchanged.

Step-by-step instructions on verifying these adjust- ments can be found in SECTION 7: SERVICE

ADJUSTMENTS.

Factory adjustments that should be verified:

1.Blade Tracking (Page 31).

2.Squaring the Blade (Page 32).

3.Blade Guide Bearings (Page 33).

-19-

Image 21
Contents Model G0622 Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Other Identification G0622 4 X 6 Metal Cutting Bandsaw SafetyG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws 110V Operation Circuit RequirementsSet Up Safety SET UPItems Needed for Set Up UnpackingInventory Box 1 Figure QtyHardware Bag not shown Hardware Recognition Chart Site Considerations Clean UpStand Assembly Components and Hardware Needed QtyTo assemble the stand To install the pulley cover Installing PulleysInstalling V-Belt To install the pulleysTo install the V-belt around the pulleys Installing Work Stop Vertical Assembly To assemble the bandsaw for vertical cutTing Adjusting table level Safety Bracket Pin Test Run Recommended Factory adjustments that should be verifiedOperation Safety Vise To adjust the angle on the viseOperations Belt Position Blade SpeedTo change the blade speeds Blade SelectionTo adjust the feed rate To adjust the blade guidesBlade Guides Feed RateOperation Tips Tips for horizontal cuttingTips for vertical cutting H5408-Blade Tensioning Gauge AccessoriesH1302-Standard Earmuffs H1302 H4979 H4977H1300 H1298 G7984 H2347 H0736 Cleaning MaintenanceSchedule LubricationTroubleshooting ServiceSymptom Possible Cause Corrective Action To change the blade on the bandsaw Blade ChangeBlade Tracking To adjust the blade tracking on the bandsawBlade Tension Squaring the Blade To tension the blade on the bandsawTo square the blade to the bed of the table Blade Guide Bearings To adjust the blade guide bearingsElectrical Components Wiring DiagramParts Breakdown Description Parts ListSliding Plate Draw Block Warranty and Returns Page Page