Grizzly G0622 owner manual Operations, Operation Safety Vise, To adjust the angle on the vise

Page 22

SECTION 4: OPERATIONS

Operation Safety

 

Vise

 

 

 

 

 

 

Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine.

Loose hair and cloth-

ing could get caught in

machinery and cause seri-

ous personal injury. Keep

loose clothing and long

hair away from moving machinery.

NOTICE

If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.

Electrocution Hazard. The motor and switch on this bandsaw are not protected against liquids. Do not use cutting fluids with this bandsaw. Serious injury could occur.

Always turn the saw OFF and allow the blade to come to a complete stop before using the vise! Failure to follow this caution may lead to injury.

The vise can hold material up to six inches wide and be set to cut angles from 0 to 45 degrees.

To adjust the angle on the vise:

1.Loosen the lock nut with a 12mm hex wrench or socket as shown in Figure 22.

2.Use the scale as a guide to set your angle or use a machinist square to square the blade to the vise as shown in Figure 23.

3.Tighten the lock nut.

Figure 22. Setting vise angle.

-20-

G0622 4" X 6" Metal Cutting Bandsaw

Image 22
Contents Model G0622 Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Other Identification Safety G0622 4 X 6 Metal Cutting BandsawG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws Circuit Requirements 110V OperationItems Needed for Set Up SET UPSet Up Safety UnpackingBox 1 Figure Qty InventoryHardware Bag not shown Hardware Recognition Chart Clean Up Site ConsiderationsComponents and Hardware Needed Qty Stand AssemblyTo assemble the stand Installing Pulleys To install the pulley coverTo install the pulleys Installing V-BeltTo install the V-belt around the pulleys To assemble the bandsaw for vertical cut Installing Work Stop Vertical AssemblyTing Adjusting table level Safety Bracket Pin Factory adjustments that should be verified Test Run RecommendedTo adjust the angle on the vise Operation Safety ViseOperations Blade Speed Belt PositionBlade Selection To change the blade speedsBlade Guides To adjust the blade guidesTo adjust the feed rate Feed RateTips for horizontal cutting Operation TipsTips for vertical cutting Accessories H5408-Blade Tensioning GaugeH1302 H4979 H4977 H1302-Standard EarmuffsH1300 H1298 G7984 H2347 H0736 Schedule MaintenanceCleaning LubricationService TroubleshootingSymptom Possible Cause Corrective Action Blade Change To change the blade on the bandsawTo adjust the blade tracking on the bandsaw Blade TrackingTo tension the blade on the bandsaw Blade Tension Squaring the BladeTo square the blade to the bed of the table To adjust the blade guide bearings Blade Guide BearingsWiring Diagram Electrical ComponentsParts Breakdown Parts List DescriptionSliding Plate Draw Block Warranty and Returns Page Page