Grizzly G0622 owner manual Maintenance, Schedule, Cleaning, Lubrication

Page 29

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

Daily Check:

Loose mounting bolts.

Damaged saw blade.

Worn or damaged wires.

Any other unsafe condition.

Clean after each use.

Monthly Check:

V-belt tension, damage, or wear.

Lubricate vise screw.

Annual Check:

Lubricate gear box.

Cleaning

Cleaning the Model G0622 is relatively easy.

After using your bandsaw, remove excess chips by sweeping. Then send chips for recycling.

G0622 4" X 6" Metal Cutting Bandsaw

Lubrication

Before applying lubricant to any area, wipe the area clean to avoid contamination. Lubricate the vice screw shown in Figure 40 with general pur- pose grease.

Figure 40. Location to lubricate vise screw.

Remove the cover on the gear box in Figure 41 and coat the gears with general purpose grease.

Gear Box

Figure 41. Gear box location.

-27-

Image 29
Contents Model G0622 Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Other Identification G0622 4 X 6 Metal Cutting Bandsaw SafetyG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws 110V Operation Circuit RequirementsSet Up Safety SET UPItems Needed for Set Up UnpackingHardware Bag not shown InventoryBox 1 Figure Qty Hardware Recognition Chart Site Considerations Clean UpTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty To install the pulley cover Installing PulleysTo install the V-belt around the pulleys Installing V-BeltTo install the pulleys Ting Installing Work Stop Vertical AssemblyTo assemble the bandsaw for vertical cut Adjusting table level Safety Bracket Pin Test Run Recommended Factory adjustments that should be verifiedOperations Operation Safety ViseTo adjust the angle on the vise Belt Position Blade SpeedTo change the blade speeds Blade SelectionTo adjust the feed rate To adjust the blade guidesBlade Guides Feed RateTips for vertical cutting Operation TipsTips for horizontal cutting H5408-Blade Tensioning Gauge AccessoriesH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Cleaning MaintenanceSchedule LubricationTroubleshooting ServiceSymptom Possible Cause Corrective Action To change the blade on the bandsaw Blade ChangeBlade Tracking To adjust the blade tracking on the bandsawTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw Blade Guide Bearings To adjust the blade guide bearingsElectrical Components Wiring DiagramParts Breakdown Description Parts ListSliding Plate Draw Block Warranty and Returns Page Page