Grizzly G0622 owner manual Blade Speed, Belt Position

Page 23

Figure 23. Squaring vise to blade.

4.Loosen the lock nut on the opposite jaw so the jaw can float, and match the angle of the workpiece.

5.Tighten the vise against the workpiece.

Note: Figure 24 shows correct methods of holding different workpiece shapes.

Figure 24. Workholding options by material

shape.

G0622 4" X 6" Metal Cutting Bandsaw

Blade Speed

The bandsaw is capable of operating at 78, 108, or 180 FPM. The speed can easily be adjusted by changing the V-belt placement. Figure 25 shows an illustration of each pulley to belt combination, and the following list provides the blade speeds in feet per minute.

��

��

�

�

Figure 25. Pulley & V-belt configuration.

Belt Position	Blade Speed
A		78 FPM
B		108 FPM
C		180 FPM

-21-

Image 23

Contents Model G0622 Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Other Identification G0622 4 X 6 Metal Cutting Bandsaw SafetyG0622 4 X 6 Metal Cutting Bandsaw Additional Safety Instructions for Metal Cutting Bandsaws 110V Operation Circuit RequirementsUnpacking SET UPSet Up Safety Items Needed for Set UpHardware Bag not shown InventoryBox 1 Figure Qty Hardware Recognition Chart Site Considerations Clean UpTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty To install the pulley cover Installing PulleysTo install the V-belt around the pulleys Installing V-BeltTo install the pulleys Ting Installing Work Stop Vertical AssemblyTo assemble the bandsaw for vertical cut Adjusting table level Safety Bracket Pin Test Run Recommended Factory adjustments that should be verifiedOperations Operation Safety ViseTo adjust the angle on the vise Belt Position Blade SpeedTo change the blade speeds Blade SelectionFeed Rate To adjust the blade guidesTo adjust the feed rate Blade GuidesTips for vertical cutting Operation TipsTips for horizontal cutting H5408-Blade Tensioning Gauge AccessoriesH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Lubrication MaintenanceCleaning ScheduleTroubleshooting ServiceSymptom Possible Cause Corrective Action To change the blade on the bandsaw Blade ChangeBlade Tracking To adjust the blade tracking on the bandsawTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw Blade Guide Bearings To adjust the blade guide bearingsElectrical Components Wiring DiagramParts Breakdown Description Parts ListSliding Plate Draw Block Warranty and Returns Page Page