Assembly
Once you have secured the machine in its pre- pared location, install the extension wings.
To assemble the double miter saw:
1.Turn the extension wings upside down on a protected surface (see Figure 9).
Support | Adjustable | |
Leg | Floor | |
| Mounts | |
Hex Bolts & | Extension | |
Wing | ||
Flat Washers | ||
|
Figure 9. Extension wing with support leg
installed.
2.Use a 13mm wrench to secure the support legs to the extension wings with the M8-1.25 x 20 hex bolts and flat washers, as shown in Figure 9.
3.Turn the support leg and extension wing assemblies right side up and mount them to the flanges on both sides of the saw table (see Figure 10) with the M8-1.25 x 20 hex bolts and flat washers.
Note: The extension wing with the scale is mounted on the left side of the machine.
Hex Bolts
& Flat Washers
Figure 10. Extension wing mounted onto the
saw table.
4.Lay a long straightedge across the extension wings and the saw table.
5.Adjust the supporting leg floor mounts so that the extension wings are level with the table, then tighten the jam nuts on the floor mounts to secure the settings.
G0641 Double Miter Saw |