Grizzly G0641 owner manual Dust Collection, To connect a dust collection hose

Dust Collection

DO NOT operate the Model G0641 without an adequate dust collection system. This saw creates substantial amounts of wood dust while operating. Failure to use a dust collec- tion system can result in short and long-term respiratory illness.

Recommended CFM at Dust Port: 400 CFM

Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust col- lector, (2) hose type and length between the dust collector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to calculate these variables is beyond the scope of this manual. Consult an expert or pur- chase a good dust collection "how-to" book.

-16-

To connect a dust collection hose:

1.Fit a 4" dust hose over the dust port, as shown in Figure 13, and secure it in place with a hose clamp.

2.Tug the hose to make sure it does not come off.

Note: A tight fit is necessary for proper per- formance.

Figure 13. Dust hose attached to dust port.

G0641 Double Miter Saw