Grizzly G0641 owner manual Replacing Blades, To replace the saw blades

Page 24

replacing blades

Replacing Blades

The teeth of saw blades are sharp and can easily cut fingers and hands. Always wear heavy leath- er gloves when handling saw blades.

The Model G0641 comes with two high-quality 12", 120-tooth blades. For best cutting results, select replacement blades that are designed for miter cuts and are of high quality.

To replace the saw blades:

1.DISCONNECT SAW FROM POWER!

2.Raise the front guard up, and remove the inner blade guard to access the blade arm assemblies and motors (see Figure 20).

Figure 20. Guards removed to access blade arm

assemblies and motors.

-22-

3.Use a 14mm wrench on the inner arbor nut (see Figure 35) and a 19mm wrench on the arbor bolt to remove the arbor bolt, arbor flange, and saw blade.

Inner Arbor Nut

Arbor Bolt

& Flange

Figure 21. Blade arbor bolt, flange, and nut (left

side shown).

Note: The left saw blade has a left-hand arbor bolt—to remove it, turn it clockwise. The right saw blade has a normally threaded arbor bolt and is removed by turning it coun- terclockwise.

4.Install the new blade on the arbor so that the teeth are pointing forward.

5.Secure the blade with the arbor flange and bolt.

Note: The arbor flange MUST be installed to ensure the blade is safely secured.

6.Reinstall the inner blade guard and secure the front guard in the lower position.

G0641 Double Miter Saw

Image 24
Contents Model G0641 Double Miter SAW Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Identification Model G0641 identificationSafety Instructions for Machinery G0641 Double Miter Saw Safety Instructions for Double Miter Saws 220V Single-Phase Circuit RequirementsSetup Setup SafetyItems Needed for Setup UnpackingInventory Inventory Figures QtyClean Up Site ConsiderationsMoving & Placing Machine To move the machineMounting to Shop Floor Bolting to Concrete FloorsAssembly To assemble the double miter sawAir Supply To connect the saw to compressed airDust Collection To connect a dust collection hoseTest Run To test run the machineOperation Safety OperationsTo make a cut Hold-downs To adjust the lowering and raising rate of the saw blades To adjust the lowering rate of the hold- downsLowering Speeds Fence Stop Replacing Blades To replace the saw bladesAccessories G1955-OxiSolvBlade & Bit CleanerG8982-Shop Fox Roller Table Forest ChopMaster H4751-12, 80 TPI, 1 ArborBoeshield T20448T20452 T20501 T20456 H0736G3326-BesseyAngle Clamp H8888-Kreg Framing TableMaintenance CleaningSchedule Lubrication To lubricate the pneumatic systemTo lubricate the lower pivot arms To lubricate the blade arbor housings To lubricate the main ram pivot pointBelt Maintenance To re-tension/replace the V-beltsPage Service TroubleshootingMiter Saw Operations Pneumatic System Aligning Pivot Arm Assembly To realign the pivot arm assembliesPneumatic Limit Switch Electrical Wiring Diagram JunctionMotor Wiring Diagram Left-handPneumatic System Diagram Parts Cabinet BreakdownCabinet Parts List DescriptionDrive System Breakdown Drive System Parts List Pivot Linkage Breakdown & Parts List Extension Wings Breakdown & Parts List Electrical & Lubrication Systems Breakdown Electrical & Lubrication Systems Parts List Pneumatic System Breakdown Pneumatic System Parts List Label Placement & List G0641 Double Miter Saw Page Page Warranty and Returns