Grizzly G0641 owner manual Maintenance, Schedule, Cleaning

Page 28

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

Daily:

Check/tighten/replace loose or worn mount- ing bolts.

Check/sharpen/replace damaged or dull saw blades.

Check/repair/replace worn or damaged wires or connectors.

Check/re-fill pneumatic and lower pivot arm oil reservoirs.

Clean/protect saw blades and table.

Check/repair any other unsafe condition.

-26-

Weekly:

Drain water from the air filter collection cup.

Clean/vacuum inside cabinet stand, and under safety hood.

Lubricate blade arbor housings and tie-rod pivot points.

Monthly:

Check/re-tension/replace V-belt tension, damage, or wear.

Cleaning

Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner like OxiSolv® spray to remove it (see Section 5: Accessories on Page 23 for more details).

Protect the unpainted cast iron surfaces on the table by wiping the it clean after every use—this ensures moisture from wood dust does not remain on bare metal surfaces.

Keep tables rust-free with regular applications of products like G96® Gun Treatment, SLIPIT®, or Boeshield® T-9 (see Page 24 for more details).

G0641 Double Miter Saw

Image 28
Contents Model G0641 Double Miter SAW Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Identification Model G0641 identificationSafety Instructions for Machinery G0641 Double Miter Saw Safety Instructions for Double Miter Saws 220V Single-Phase Circuit RequirementsSetup Setup SafetyItems Needed for Setup UnpackingInventory Inventory Figures QtyClean Up Site ConsiderationsMoving & Placing Machine To move the machineMounting to Shop Floor Bolting to Concrete FloorsAssembly To assemble the double miter sawAir Supply To connect the saw to compressed airDust Collection To connect a dust collection hoseTest Run To test run the machineOperations Operation SafetyTo make a cut Hold-downs To adjust the lowering rate of the hold- downs To adjust the lowering and raising rate of the saw bladesLowering Speeds Fence Stop Replacing Blades To replace the saw bladesAccessories G1955-OxiSolvBlade & Bit CleanerG8982-Shop Fox Roller Table Forest ChopMaster H4751-12, 80 TPI, 1 ArborBoeshield T20448T20452 T20501 T20456 H0736G3326-BesseyAngle Clamp H8888-Kreg Framing TableCleaning MaintenanceSchedule To lubricate the pneumatic system LubricationTo lubricate the lower pivot arms To lubricate the blade arbor housings To lubricate the main ram pivot pointBelt Maintenance To re-tension/replace the V-beltsPage Service TroubleshootingMiter Saw Operations Pneumatic System Aligning Pivot Arm Assembly To realign the pivot arm assembliesPneumatic Limit Switch Electrical Wiring Diagram JunctionMotor Wiring Diagram Left-handPneumatic System Diagram Parts Cabinet BreakdownCabinet Parts List DescriptionDrive System Breakdown Drive System Parts List Pivot Linkage Breakdown & Parts List Extension Wings Breakdown & Parts List Electrical & Lubrication Systems Breakdown Electrical & Lubrication Systems Parts List Pneumatic System Breakdown Pneumatic System Parts List Label Placement & List G0641 Double Miter Saw Page Page Warranty and Returns