Grizzly G1022SM instruction manual Checking V-belt alignment

Motor Mount Bracket

Motor Mount Plate

Figure 18. Installing the motor mount bracket.

6.Line up the hole in the motor bracket with the hole in the motor mount plate and insert the motor pivot rod. Make sure the groove in the rod lines up with the setscrew in the mount bracket.

7.Tighten the setscrew.

8.Turn the arbor tilting handwheel until the arbor is set to 0¡.

9.Slide the motor assembly onto the linking bars through the holes in the motor bracket as shown in Figure 19.

10.Line up the setscrews with the grooves on the linking bars and tighten them.

Linking Bars

Figure 19. Attaching motor to linking bars.

G1022 Series Table Saws

11.Lift the motor up and slip the V-belt over the grooves in the pulleys. Slowly release the motor, allowing its weight to add tension to the V-Belt as shown in Figure 20.

!

Figure 20. Attaching the V-belt to the motor.

12.Place a straightedge across the arbor pulley and the motor pulley. The straightedge should run across both pulleys evenly as shown in Figure 21.

13.If the motor needs to be adjusted, loosen the mounting bolt tightened in Step 4.

14.Adjust the motor on its mount until the pul- leys are aligned, then tighten all the mount- ing bolts.

!

Figure 21. Checking V-belt alignment.

-23-