Grizzly G1012 instruction manual Legs, braces, and one stand side Attached to stand

Page 15

Figure 5. Motor bracket attached to stand top.

4.Mount the motor onto the motor bracket. Secure with (4) 516" -18 x 34" hex head bolts, washers and nuts. Hand-tighten for now.

5.Place the smallest key in the groove on the motor shaft. Line up the key on the shaft with the pulley keyway. Slide the motor pulley (the small triple-grooved pulley) onto the motor shaft. Insert one of the small 14"-20 x 14" setscrews in the bottom of the middle pul- ley groove and tighten with the included 3mm hex wrench as shown in Figure 6.

Figure 6. Securing motor pulley to motor shaft.

6.Attach the four legs to the top of the stand using the 5/16"-18 x 1/2" carriage bolts, wash- ers and nuts provided. Do not tighten down bolts completely at this time.

G1012 18" Bandsaw

7.Attach the two horizontal braces to the legs and secure with the 5/16"-18 x 1/2" carriage bolts, washers and nuts provided. Attach one of the stand sides on the opposite side of the pulley slot in the stand top. Your assembly should now look like Figure 7.

Figure 7. Legs, braces, and one stand side

attached to stand

NOTICE

As an option, you may attach the other stand side to the stand at this time. Performing this step now will ease assem- bly of this part, but it will limit your access to the motor pulley when installing V-belts.

Figure 8. Legs, braces, and both stand sides

assembled as an option.

-13-

Image 15
Contents HEAVY-DUTY Bandsaw Page Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Bandsaws Circuit Requirements 220V Operation FusingGrounding Extension Cords Commentary General InformationSee Figure Unpacking Piece InventoryInside Bags Qty Hardware BagsHardware Recognition Chart Site Considerations Clean upAssembly Order of AssemblyStand Legs, braces, and one stand side Attached to stand Bandsaw unit mounted to stand Pulleys Belts Belts mounted on pulleys Belt GuardTo mount the table to the bandsaw unit To install the upper and lower blade guides Blade GuidesFence Controls AdjustmentsTo adjust the tension Blade TrackingBlade Tension To adjust guide assembly alignment on guide post Guide PostTo set the guide-blocks within the guide- block holder Lower Blade Guide Assemblies Blade Changes Table AdjustmentsSquaring table to blade back G1012 18 Bandsaw To adjust the miter slot parallel to the band- saw bladeTo skew your fence Fence Adjustment Blade LeadTo verify if the the upper and lower wheels are coplanar Wheel AlignmentShimming a wheel Coplanar diagram G1012 18 BandsawOperations Test RunOverview Tooth Style Blade InformationBlade Length Blade WidthTooth Pitch Blade CareBlade Breakage To crosscut with the Model G1012 RippingCrosscutting To rip with the Model G1012Crosscutting with miter gauge ResawingCutting Curves Stacked CutsTo complete a stacked cut Maintenance MiscellaneousLubrication G1012 18 Bandsaw Closure Machine Data Sheet G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw Upper Frame ARM Switch Troubleshooting Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INC