Grizzly G1012 instruction manual Bandsaw unit mounted to stand

Page 16

8.Prepare the four rubber feet by placing the 516"-18 x 1" bolts through the rubber feet and tightening the 516"-18 hex nuts as shown in

Figure 9.

Figure 9. Preparing rubber feet for installation.

9.Install each rubber foot on the bottom of each leg. Thread on another 516"-18 hex nut to tighten the rubber foot to the leg as shown in Figure 10.

Figure 10. Rubber foot installed.

10.Flip the stand upright and adjust it back and forth so it is level and symmetrical on the legs. Now, tighten all of the stand bolts (except the last stand side if you left it off) to secure the bandsaw unit in place.

At this point, place the bandsaw on the stand. Ensure that the bandsaw pulley shaft is posi- tioned over the rectangular hole in the stand.

When the bandsaw is positioned on the stand, fasten it (as shown in Figure 11) with the (4) 12"- 12 x 112" hex head bolts, washers and nuts pro- vided. Tighten securely.

Figure 11. Bandsaw unit mounted to stand.

The Model G1012 can be awkward to handle without assistance. The bandsaw unit is also very unstable until it is permanently mounted to the stand. Failure to use caution during assembly could lead to serious per- sonal injury.

-14-

G1012 18" Bandsaw

Image 16
Contents HEAVY-DUTY Bandsaw Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Bandsaws 220V Operation Fusing Circuit RequirementsGrounding Extension Cords General Information CommentaryUnpacking Piece Inventory See FigureHardware Bags Inside Bags QtyHardware Recognition Chart Clean up Site ConsiderationsOrder of Assembly AssemblyStand Legs, braces, and one stand side Attached to stand Bandsaw unit mounted to stand Pulleys Belts Belt Guard Belts mounted on pulleysTo mount the table to the bandsaw unit Blade Guides To install the upper and lower blade guidesFence Adjustments ControlsBlade Tracking To adjust the tensionBlade Tension Guide Post To adjust guide assembly alignment on guide postTo set the guide-blocks within the guide- block holder Lower Blade Guide Assemblies Table Adjustments Blade ChangesTo adjust the miter slot parallel to the band- saw blade Squaring table to blade back G1012 18 BandsawFence Adjustment Blade Lead To skew your fenceWheel Alignment To verify if the the upper and lower wheels are coplanarCoplanar diagram G1012 18 Bandsaw Shimming a wheelTest Run OperationsOverview Blade Information Blade LengthBlade Width Tooth StyleBlade Care Tooth PitchBlade Breakage Ripping CrosscuttingTo rip with the Model G1012 To crosscut with the Model G1012Resawing Crosscutting with miter gaugeStacked Cuts Cutting CurvesTo complete a stacked cut Miscellaneous MaintenanceLubrication G1012 18 Bandsaw Closure Machine Data Sheet G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw Upper Frame ARM Switch Troubleshooting Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WA