Grizzly G1012 instruction manual Belt Guard, Belts mounted on pulleys

Page 19

6.To tighten the belt from the stepped pulley to the motor, loosen the nuts on each motor adjustment bolt and lower the motor into position. The weight of the motor is sufficient for the amount of tension required. Tighten the nuts against the motor plate, so your assembly looks similar to Figure 17.

Figure 17. V-belts mounted on pulleys.

Belt Guard

1.When all belts are installed, aligned, and tightened, fasten the last stand side to the stand legs. (If this has already been done, skip this step.)

2.Place the belt cover over the pulleys on the bandsaw unit and secure with the (2) 1⁄4"-20 x 1⁄2" hex bolts, (4) 1⁄4" washers, and (2) 1⁄4"- 20 hex nuts. Your assembly should now look similar to Figure 18.

Figure 18. Belt cover mounted to stand.

DO NOT operate bandsaw with cover removed or serious personal injury may occur!




G1012 18" Bandsaw		-17-

Image 19

Contents HEAVY-DUTY Bandsaw Page Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Bandsaws Circuit Requirements 220V Operation FusingGrounding Extension Cords Commentary General InformationSee Figure Unpacking Piece InventoryInside Bags Qty Hardware BagsHardware Recognition Chart Site Considerations Clean upOrder of Assembly AssemblyStand Legs, braces, and one stand side Attached to stand Bandsaw unit mounted to stand Pulleys Belts Belts mounted on pulleys Belt GuardTo mount the table to the bandsaw unit Blade Guides To install the upper and lower blade guidesFence Controls AdjustmentsBlade Tracking To adjust the tensionBlade Tension Guide Post To adjust guide assembly alignment on guide postTo set the guide-blocks within the guide- block holder Lower Blade Guide Assemblies Blade Changes Table AdjustmentsSquaring table to blade back G1012 18 Bandsaw To adjust the miter slot parallel to the band- saw bladeTo skew your fence Fence Adjustment Blade LeadTo verify if the the upper and lower wheels are coplanar Wheel AlignmentShimming a wheel Coplanar diagram G1012 18 BandsawTest Run OperationsOverview Tooth Style Blade InformationBlade Length Blade WidthBlade Care Tooth PitchBlade Breakage To crosscut with the Model G1012 RippingCrosscutting To rip with the Model G1012Crosscutting with miter gauge ResawingStacked Cuts Cutting CurvesTo complete a stacked cut Miscellaneous MaintenanceLubrication G1012 18 Bandsaw Closure Machine Data Sheet G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw Upper Frame ARM Switch Troubleshooting Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INC