Grizzly G1012 instruction manual To mount the table to the bandsaw unit

Page 20

Table

To mount the table to the bandsaw unit:

1.Locate the trunnion casting from your loose parts. The mounting bolts are already in the table saw unit, near the lower blade guides. Remove these bolts and their washers.

2.Line up the holes on the trunnion casting with the roll pins that are in the bandsaw unit.. Tap the trunnion casting down onto the bandsaw unit. Secure with the hex bolts and washers as shown in Figure 19.

Figure 19. Trunnion casting mounted to

bandsaw unit.

3.Using the table slot for access, remove the table pin and guide the bandsaw table around the blade so the blade is centered in the table. Rotate the table 90˚ and carefully place the table on the trunnions, so that the threaded studs go through the holes in the trunnions.

4.Using the two plastic knobs from your hard- ware bags, secure the table to the trunnions as shown in Figure 20.

-18-

Trunnion Pointer

Figure 20. Table mounted on trunnion casting.

5.The Model G1012 includes a positive stop bolt for quick table adjustments. Locate the 38"-16 x 3" hex bolt from your hardware bag and thread it into the trunnion casting as shown in Figure 21. Use a 38"-16 hex nut from the hardware bag to lock the bolt in place.

Figure 21. Positive stop location/installation.

6.Fit the tapered table pin in the opening of the access slot.

7.After verifying that the positive stop holds the table 90˚ to the blade, set the trunnion point- er to 0˚ on the trunnion gauge.

Always keep the tapered table pin in place when operating the bandsaw.

G1012 18" Bandsaw

Image 20
Contents HEAVY-DUTY Bandsaw Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Bandsaws 220V Operation Fusing Circuit RequirementsGrounding Extension Cords General Information CommentaryUnpacking Piece Inventory See FigureHardware Bags Inside Bags QtyHardware Recognition Chart Clean up Site ConsiderationsStand AssemblyOrder of Assembly Legs, braces, and one stand side Attached to stand Bandsaw unit mounted to stand Pulleys Belts Belt Guard Belts mounted on pulleysTo mount the table to the bandsaw unit Fence To install the upper and lower blade guidesBlade Guides Adjustments ControlsBlade Tension To adjust the tensionBlade Tracking To set the guide-blocks within the guide- block holder To adjust guide assembly alignment on guide postGuide Post Lower Blade Guide Assemblies Table Adjustments Blade ChangesTo adjust the miter slot parallel to the band- saw blade Squaring table to blade back G1012 18 BandsawFence Adjustment Blade Lead To skew your fenceWheel Alignment To verify if the the upper and lower wheels are coplanarCoplanar diagram G1012 18 Bandsaw Shimming a wheelOverview OperationsTest Run Blade Information Blade LengthBlade Width Tooth StyleBlade Breakage Tooth PitchBlade Care Ripping CrosscuttingTo rip with the Model G1012 To crosscut with the Model G1012Resawing Crosscutting with miter gaugeTo complete a stacked cut Cutting CurvesStacked Cuts Lubrication MaintenanceMiscellaneous G1012 18 Bandsaw Closure Machine Data Sheet G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw G1012 18 Bandsaw Upper Frame ARM Switch Troubleshooting Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WA