Grizzly G0555 Mounting Bandsaw, Mounting Trunnion Base, To mount the trunnion base

Mounting Bandsaw

Get assistance from an- other person when lifting the bandsaw onto the stand or moderate per- sonal injury may occur.

To mount the bandsaw to the stand:

1.Get an assistant to help you lift the bandsaw and place it on top of the stand.

2.Line up the mounting holes on the bandsaw base with those on the stand top, so that the front of the bandsaw is closer to the stand edge than the back of the bandsaw.

3.Secure the bandsaw to the stand with the (4) M8-1.25 x 35 hex bolts, (8) 8mm flat wash- ers, (4) 8mm lock washers, and (4) M8-1.25 hex nuts from the hardware bag. The band- saw should now be mounted to the stand as shown in Figure 13.

Figure 13. Bandsaw mounted to stand.

Mounting

Trunnion Base

To mount the trunnion base:

1.Place the trunnion base on the bandsaw as shown in Figure 14.

2.Fasten the trunnion base to the bandsaw with the (2) M8-1.25 x 30 hex bolts and (2) 8mm lock washers from the hardware bag.

Trunnion

Base

Figure 14. Installing trunnion base.

G0555 14" Ultimate Bandsaw -15-