Assembling Stand
Some metal parts may have sharp edges that can cause minor injury. Please examine the edges of all metal parts BEFORE handling them and be careful WHILE handling them.
To assemble the stand:
1.Lay one of the stand sides on its back and secure the two lower braces with (4)
2.Attach the two upper braces to the stand side in the same manner with (4)
Figure 7. Braces attached to stand side.
3.Attach the second stand side to the assem- bly with (8) M6-0.8 x 16 hex bolts, (8) 6mm flat washers, and (8) M6-0.8 flange nuts from the hardware bag. Your assembly should now look like Figure 8.
Figure 8. Second stand side attached
to assembly.
4.Thread a 3Ú8"-16 hex nut onto each foot and follow it with a 10mm flat washer.
5.Install the feet into the corner brace of the stand, and secure it with another 3Ú8"-16 hex nut and 10mm flat washer as shown in Figure 9.
Figure 9. Foot installed into stand corner.
6.Adjust the feet so that they are approximate- ly the same height. This step will make level- ing the stand easier.
G0555 14" Ultimate Bandsaw |