7.Place the 2 top stand braces into the under- side of the stand top.
8.Line the braces up with the holes and secure only the end shown in Figure 10 with (2) M8- 1.0 x 16 carriage bolts and (2) M8-1.0 flange nuts from the hardware bag. The holes in the other end of the brace must be left open to mount the bandsaw unit.
Figure 10. Installing braces on stand top.
9.Turn the stand assembly upright and secure the stand top to the stand assembly with the remaining (8) M8-1.0 x 16 carriage bolts and
(8)M8-1.0 flange nuts from the hardware bag. The stand assembly is now complete and should look similar to Figure 11.
Figure 11. Stand top installed on
stand assembly.
-14-
10.Place a level across the stand top as shown in Figure 12 and adjust the feet as neces- sary to make the stand level. Turn the level 90û and adjust the stand to be level again.
Repeat these two adjustments until the stand is level in both directions.
Figure 12. Leveling stand.
11.Tighten the hex nuts on the feet, so that they are against the underside of the stand and will lock the feet in place to keep the stand level.
G0555 14" Ultimate Bandsaw