Global Machinery Company DB305SMS Turning on and off, Turning on Redeye laser line Generator

Turning on and off
	S
1. To turn the saw on depress
and hold the on/off trigger
switch (24) (fig. S).
2. To turn the saw off release
the on/off trigger switch (24).

Turning on the
	T
REDEYE® laser line
generator

The REDEYE® laser line generator emits 2 intense narrow beams of pure red light to guide you as you cut. It improves operator cutting vision, enables faster set-up,

increases accuracy and improves safety. To turn on the laser lines press the laser light on/off switch (2) (fig. T). To turn off the laser press the laser light on/off switch (2) one more time.

Setting the table
	U
square with the blade

1.Make sure that the electrical plug is removed from the power point.

2.Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the transport position.

3.Loosen the mitre lock (25) (fig. U).

4.Rotate the table (21) until the pointer is positioned at 0º.

5. Tighten the mitre lock (25).
	V
6. Loosen the bevel lock (16)
and set the saw arm (5) at
0º bevel (the blade at 90º
to the mitre table). Tighten
the bevel lock (16) (fig. V).

7.Place a set square against the table (21) and the flat part of the blade. (fig. W)

Note. Make sure that the

square contacts the flat part W of the saw blade, not the

teeth.

8.Rotate the blade by hand and check the blade-to- table alignment at several points.

9.The edge of the set square

and the saw blade should be parallel.

10.If the saw blade angles away from the set square, adjust as follows.

11.Use a 13mm wrench

or adjustable wrench X

to loosen the lock nut securing the 0° bevel adjustment screw (35) (fig. X). Also, loosen the bevel lock (16).

13