Global Machinery Company DB305SMS, DB250SMS Maintenance Power cord maintenance, Cleaning

Page 21

Maintenance

WARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making and adjustments or maintenance procedures.

Power cord maintenance

If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.

Cleaning

1.Keep the tool’s air vents unclogged and clean at all times.

2.Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.

3.Re-lubricate all moving parts at regular intervals.

4.Never use caustic agents to clean plastic parts.

CAUTION. Do not use cleaning agents to clean the plastic parts of the saw. A mild detergent on a damp cloth is recommended.

General inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

Image 21

Contents Double Bevel Slide Compound Mitre Saw Contents Specifications Description of symbolsDear Customer IntroductionSafety rules for laser lights General safety instructionsDamage to hearing if effective earmuffs are not worn Page Additional safety rules for mitre saws Take additional care when trenching slotting Wear gloves when handling saw blades and rough materialsEnsure that the arm is properly secure when bevelling Select saw blades in relation to the material being cutAccessories Know your product Transportation UnpackingBench mounting Stabiliser barClamp assembly Bevel adjusterSlide lock Mitre table lockSpindle lock button Rotating lower Blade guardDust bag Switch 24 fig. S Setting the tableTurning on and off Turning on Redeye laser line GeneratorTo the base fig. d Setting the fence Square with the tableTighten the screws securing the fence Retighten the bevel lockChanging a blade Retighten the screw securing the mitre scale pointerRaise the saw arm 5 to its highest position Up and press Outer blade Washer where they Contact the bladeDirection as the blade Screw has a left hand Thread fig. l That the inner bladeAcross the grain Cross-cutting without slide actionMade with the mitre table Set at 0º fig. q. Mitre By loosening the clampBevel cut Cross-cutting With slide actionBevel cut is made by Angled to the fenceCompound mitre cut Adjusting the laser linesUsing the laser line generator Do not stare directly at the y laser beamTowards the eye of a person for longer than 0.25s Maintenance Power cord maintenance CleaningGeneral inspection Page Page Save this Manual for future reference