Global Machinery Company DB250SMS, DB305SMS Save this Manual for future reference

Page 24

Carefully read the entire Instruction Manual before using this product.

Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand)

When you make your call, please have the following information at hand:

•GMC Product Type • GMC Product Code

A GMC Service Engineer will take your call and, in most cases, will be able to solve your problem over the phone.

You are welcome to use this phone-in service to make suggestions or give comments about any GMC product.

With continuing product development changes may have occurred which render the product received slightly different to that shown in this instruction manual. The manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country to country.

The GMC 777 Helpline operates from 7am to 7pm, 7 days a week (EST). This allows you to contact GMC directly with any queries and technical questions you have regarding

our products.

45–55 South Centre Road

Melbourne Airport

Victoria, Australia 3045

Tel: (03) 8346 1100 Fax: (03) 8346 1200

Save this Manual for future reference.

Image 24

Contents Double Bevel Slide Compound Mitre Saw Contents Description of symbols SpecificationsDear Customer IntroductionSafety rules for laser lights General safety instructionsDamage to hearing if effective earmuffs are not worn Page Additional safety rules for mitre saws Wear gloves when handling saw blades and rough materials Take additional care when trenching slottingEnsure that the arm is properly secure when bevelling Select saw blades in relation to the material being cutAccessories Know your product Unpacking TransportationBench mounting Stabiliser barBevel adjuster Clamp assemblySlide lock Mitre table lockSpindle lock button Rotating lower Blade guardDust bag Setting the table Switch 24 fig. STurning on and off Turning on Redeye laser line GeneratorSetting the fence Square with the table To the base fig. dTighten the screws securing the fence Retighten the bevel lockChanging a blade Retighten the screw securing the mitre scale pointerRaise the saw arm 5 to its highest position Outer blade Washer where they Contact the blade Up and pressDirection as the blade Screw has a left hand Thread fig. l That the inner bladeCross-cutting without slide action Across the grainMade with the mitre table Set at 0º fig. q. Mitre By loosening the clampCross-cutting With slide action Bevel cutBevel cut is made by Angled to the fenceAdjusting the laser lines Compound mitre cutUsing the laser line generator Do not stare directly at the y laser beamTowards the eye of a person for longer than 0.25s Maintenance Power cord maintenance CleaningGeneral inspection Page Page Save this Manual for future reference