12.Adjust the 0° bevel adjustment screw (35) with the 6mm hex key to bring the saw blade into alignment with the square (fig. Y).
13.Loosen the 2 Phillips head screws holding the pointer of the bevel scale
(17)and adjust the position of the pointer so that it accurately indicates zero on the scale (fig. Z). Retighten the screw.
14.Retighten the bevel lock
(16)and the lock nut securing the 0° bevel adjustment screw (35).
Note. The above procedure can also be used to check the angle of the saw blade to the table at either 45º bevel angle to the left or to the right. The 45° bevel adjustment screws (33 & 34) are on opposite sides of the saw arm. You will require a 13mm wrench or adjustable wrench (not supplied) for the lock nut (fig. a) and the 6mm hex key for the set screws (fig. b).
Y
Z
a
b
Setting the fence |
| |
c | ||
square with the table | ||
|
1.Make sure that the electrical plug is removed from the power point.
2.Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the transport position.
3.Loosen the mitre lock (25). d
4.Rotate the table (21) until the pointer is positioned at 0º.
5.Tighten the mitre lock (25).
6.Using the 6mm hex key loosen the hex screw securing the top piece of the right hand side fence (fig. c) and remove this
top section. | e |
7.Using the 6mm hex key provided, loosen the four screws securing the fence
(19)to the base (fig. d).
8.Place a square against the fence (19) and alongside the blade (fig. e).
9.Adjust the fence (19) until it is square with the blade.
10.Tighten the screws securing the fence (19).
14