Woodstock W1676 Avoiding Potential Injuries, Never place fingers close to moving disk

Page 11

AVOIDING POTENTIAL INJURIES

Figure 3. Never place fingers close to moving disk.

Figure 4. Never use the right side of disk. Upward rotation of disk can propel workpiece into the air.

Figure 5. Always unplug sander when adjusting.

Figure 6. Never place hands near back stop. On small workpieces always use push blocks.

-9-

Image 11
Contents Combination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For SandersGrounding Electrical Requirements110V Operation Extension Cords220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Dust Ports Back StopQuick Release To install the working table next to the discWorking Table Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionStep Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingLubrication MaintenanceTable And Base Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA