Woodstock instruction manual W1676 Combination Sander, 220VOLT

Page 30

Disconnect power from machine before performing any electrical service. Failure to do this will result in a shock hazard leading to injury or death.

W1676 Combination Sander

110 VOLT

MOTOR WIRES

BLACK

YELLOW

WHITE

RED

NOTE: THE WIRES FROM THE POWER SUPPLY, BESIDES THE GREEN GROUND WIRE, ARE INTERCHANGABLE, THEREFORE COLORS ARE NOT SPECIFIED.

GREEN (GROUND) TO 110 VOLT POWER SUPPLY

6A

220VOLT

		MOTOR WIRES

	BLACK			YELLOW

RED
RED					WHITE

GREEN (GROUND)

TO 220 VOLT

POWER SUPPLY

-28-

©2001 Woodstock International

Image 30

Contents Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Back Stop Dust PortsTo install the working table next to the disc Working TableQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning StepChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainMaintenance Table And BaseLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA