Woodstock W1676 instruction manual Table Tilt, To adjust the working table angle

Page 24

Table Tilt

To adjust the working table angle:

1.Set the working table angle to the 90° mark on the scale.

2.Using a 90° square, adjust the working table so it is perpendicular to the sanding disc as shown in Figure 29.

3.Loosen the screw holding the angle indicator and set it to the 90° mark on the scale.

4.Using a 90° square, check to see if the miter slot is perpendicular to the sanding disc as shown in Figure 30.

5.To adjust, loosen the three screws shown in Figure 31. Wiggle the table until the miter slot is parallel to the sanding disc and tight- en the adjustment screws.

Make sure the gap between the working table edge and the sanding disc is no larger than 1⁄8". Your fingers could get caught in the gap, causing serious personal injury.

Figure 29. Checking table alignment.

Figure 30. Checking miter gauge alignment.

Figure 31. Table adjustment screws.

-22-

Image 24

Contents Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discElectrical Requirements 110V OperationExtension Cords Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Back Stop Dust PortsTo install the working table next to the disc Working TableQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning StepChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainMaintenance Table And BaseLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA