Woodstock W1676 instruction manual Vertical Positioning, Step

Page 22

Vertical Positioning

The belt sander arm can be moved to a vertical arrangement.

1.Remove the belt dust port.

2.Loosen the two nuts located on the bracket behind the pulley cover as shown in Figure 23. We recommend using a 12mm open-end wrench for clearance purposes.

3.When the nuts are loose, rotate the sanding belt frame to the vertical position as shown in Figure 24.

4.Tighten down the nuts that were loosened in

Step 2.

The working table can also be repositioned next to the vertical surface of the sanding belt. Remove the working table assembly and support bar from the sander base, and reposition it in the mounting hole behind the motor as shown in

Figure 25.

Figure 23. Vertical positioning bolts.

Figure 24. Belt sander in vertical position.

Figure 25. Working table mounting hole when

vertical sanding.

-20-

Image 22

Contents Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Idler Roller Sanding Unit To BaseSanding Disc Back Stop Dust PortsWorking Table To install the working table next to the discQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning StepChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainTable And Base MaintenanceLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA