Woodstock W1676 instruction manual

Page 2

WARNING

Some dust created by power sanding, sawing, grind- ing, drilling, and other construction activities con- tains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

Lead from lead-based paints.

Crystalline silica from bricks, cement, and other masonry products.

Arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well venti- lated area, and work with approved safety equip- ment, such as those dust masks that are specially designed to filter out microscopic particles.

Image 2
Contents Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Back Stop Dust PortsQuick Release To install the working table next to the discWorking Table Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning StepChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainLubrication MaintenanceTable And Base Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA