Woodstock W1676 instruction manual Box Bellingham, Wa

Page 38

FOLD ALONG DOTTED LINE

Place

Stamp

Here

WOODSTOCK INTERNATIONAL, INC.

P.O. BOX 2309

BELLINGHAM, WA 98227-2309

FOLD ALONG DOTTED LINE

TAPE ALONG EDGES--PLEASE DO NOT STAPLE

Page 37 Page 38
Image 38
Page 37 Page 38
Contents Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Back Stop Dust PortsQuick Release To install the working table next to the discWorking Table Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning StepChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainLubrication MaintenanceTable And Base Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Dust Cover Page Page Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents